It's designed to catch the points on the bolt or nut better than the normal Joe Blow wrench. Been there, done that.Ĭompare it with Stanley or Craftsman (I wonder who makes Craftsman these days) and you will note a subtle difference on the 12 point wrench. If bad luck holds out you might find it's a left hand thread and you've been trying to turn a right turning bolt. Also, try turning it in before trying to take it out. Usually it'll break the bolt before it rounds the head off.īut when that's going to happen, the usual thing is to stop before it gets too battered up and you go to other measures, such as heat, lots of heat. they grab better and it's tough to round out the corners of a tight bolt. It means you don't have to make trips to the local Lows or Menards to get more of the same. A big difference that goes way beyond whether or not a "lifetime" warranty. Not 100% perfect, but they've helped me many times. Most of the hand wrenches have been machined to grab nuts or bolts that have the points rounded out. Compare it with Stanly or Craftsman (I wonder who makes Craftsman these days) and you will note a subtle difference on the 12 point wrench. One more thing and I'll shut up about Snap-On.
0 Comments
Leave a Reply. |